diy posted by

Make your PC case more cable-friendly with this DIY tip

If you’ve ever assembled your own PC, you’ve no doubt discovered just how many cables there are on the inside. I’m the type of person that will spend a half hour routing wires so that the end result is as clean and free of clutter as possible. It helps when the case I’m working with has holes for cable management. Unfortunately not all cases have these, and if you don’t have the budget for a new chassis, you’re stuck with a mess case, right? Well if you have the right tools and a few extra bucks, you can add these holes yourself.

Now, you might be thinking that cutting a few holes in the side of a PC case wouldn’t be that hard, but there is a little more to it. Namely, you’ll need to cover up the bare metal of the holes, lest your cables get damaged by the sharp edges. A few rubber grommets should do the trick. If this quick and easy mod sounds like something your case needs, check out the full guide here.

Scott – who has written posts on The Red Ferret Journal.


Comments are closed.

comments powered by Disqus

Side Advert

Chinavasion
DHgate Cheap electronics gadgets
BRANDO
Firebox

FB Like Box

Personnel

Managing Editor:
Nigel Powell

Deputy Editor:
Donyae Coles
Editor at Large:
Dan Ferris
Senior Ecological Editor:
Debra Atlas
Senior Motoring Editor:
Nick Johnson
Reviews Editor:
Simon Bossuyt

Write For Us

Red Ferret Video Reviews